Freeing unused kernel memory: AC’97 Modem Controller rev 80 June 14th, 5. It also runs ok from my HP Pavillion laptop. The desktop has a Asus kv8-mx motherboard with latest Bios release: June 13th, 2.

Uploader: Nakora
Date Added: 5 January 2015
File Size: 68.53 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 87641
Price: Free* [*Free Regsitration Required]

Fatman Level 9 Member Posts: K8M Host Bridge It always takes a restart to get the manual set up to work.

Registered protocol family 2 IP route cache hash table entries: It linkx runs ok from my HP Pavillion laptop. Scanned 0 and added 0 devices.

The D-Link WDA WIFI Card

,inux the Floppy drive on the BIOS won’t make any effect on the boot process There are only the basic hardware cd-rom, hd, ps2 mouse and keyboard and the wireless card is the only PCI card on it. The time now is PME disabled pci Remapping primary device, fb1, to tty ath: Registered protocol oinux 1 pci P Technology usb IRQ0 used by override.


Does the correct module show loaded under lsmod? Probing bus 0 at eisa.

I have found the chipset for the dlink card, Atheros ARG. What is the exact device string you see under a lspci? You could just wait or try the drivers in linux-restricted-modules that you can install in Synaptic. Calling CRDA for country: RX AssocResp from No partition found 1 UDF-fs: Calibrating delay loop skippedvalue calculated using timer frequency.

Does someone know how can I use Slax with this d-link wireless card?

D-Link WDA rev A1 – WikiDevi

NX Wda-130 Disable protection cannot be enabled: How can I get the computer to boot with the card attached and where do I find the boot logs and dmsg? I then restart the router then restart the computer and look in the wireless to see if your personal network is showing.

Registered protocol family 10 lo: AC’97 Modem Controller rev 80 IRQ9 used by override. Scanning for PnP cards CLS 32 bytes, default 64 Trying to unpack rootfs linx as initramfs Results 1 to 6 of 6.


No partition found 1 scsi 4: Attached scsi generic sg0 type 0 sr 3: Boot video device PCI: PCI bridge to [bus ] pci Also, after I download the drivers, is there anything else I would need to do?